DIFFLOCKEDTHE REGISTRY NAMED MODEL · 1972–86
NAMED MODELSpecial · PoliceMilitary · UKUnited Kingdom

VPK Lightweight.

A Series III Lightweight wearing the Northern Ireland Vehicle Protection Kit: a bolt-on glass-reinforced-plastic hard top and rounded lower side panels, mesh over the screen and door glass, the spare on the cab roof, a wire catcher up the screen pillar and CONFIDENTIAL TELEPHONE 0800 666999 stencilled in yellow on the side.

Drive it in the gameSources & evidence
VPK Lightweight — Series III, 1972–86 — AI rendering impression, not a photograph
BASE VEHICLESeries III 88″BUILT BYRover Company / British Leyland, Solihull (Series III ½-ton Lightweight)IN SERVICE1972–86OPERATED INUnited KingdomPRODUCTIONunknownLAYOUT4 wheels · 88″

The record

Internal-security operations in Northern Ireland began in 1969, and in the early 1970s the Army fielded the Vehicle Protection Kit — a set of glass-reinforced-plastic panels that turned a soft-skin Land Rover into a protected patrol vehicle without a new chassis. The Ministry approached the Royal Navy, which had GRP experience from submarine conning towers and fittings, for the moulding; the kit could be fitted with standard hand tools in about 32 to 35 man-hours, and taken off again when the vehicle went back to ordinary duties. It gave a full hard top with a rear door and small protected windows, wire-mesh guards hinged over the windscreen and the door glass against thrown missiles, and deep lower side panels curving in beneath the body to shield the wheels and underside. With the extra weight, large cylindrical rubber pads (Aeon springs) replaced the bump stops between axle and chassis.

A later HV kit — High Velocity, proof against high-velocity rounds — took the unladen weight to over 2,500 kg and served as the interim protected Land Rover until the armoured 110 Patrol Vehicle arrived in 1986. In the late 1980s it was common for units to stencil the body sides, in yellow or red, with the Confidential Telephone number 0800 666999, the RUC's anonymous information line — done by the units themselves, and not always very neatly.

The registry's model is the Lightweight in kit form as a surviving example shows it: the standard Series III Lightweight front with its headlamps in the wings and the shared bumperettes, a flat-sided GRP top with the Series hard-top crown, mesh screens over the glass, the rounded skirts, the spare lying on the cab roof, a wire catcher — the sharpened steel bar up the windscreen pillar that lifts and cuts wires strung across a road — and the three-line yellow stencil on the rear side panel. The registration is not legible and is left as a placeholder.

Specification

MANUFACTURERRover Company / British Leyland, Solihull (Series III ½-ton Lightweight)
MODIFIER / COACHBUILDERBritish Army workshops (Vehicle Protection Kit; GRP moulding with Royal Navy expertise)
MANUFACTUREDLightweight 1972–84; VPK early 1970s to the mid-1980s, HV kit until the 110 APV of 1986
ENGINE2.25 L petrol inline-four
PRODUCTION RUNunknown (kits fitted to in-service Lightweights and Series IIIs)
COUNTRY OF ORIGINUnited Kingdom
OPERATED INUnited Kingdom
STATUSretired; examples preserved
KITGlass-reinforced-plastic protection kit, bolt-on, 32–35 man-hours to fit with hand tools
UNLADEN WEIGHT HVover 2,500 kg (HV kit)
SUSPENSIONAeon rubber springs in place of the bump stops
MARKINGCONFIDENTIAL TELEPHONE 0800 666999, stencilled by units in yellow or red in the late 1980s
RECORD KINDNamed model
MODEL LINESeries III
WHEELS4
NOMINAL WHEELBASE88″
CATEGORYSpecial · Police, Military · UK

Catalogue fields describe the vehicle's structure and body as this registry records it. They are not certified factory measurements, and no performance figures are published here.

Variants & colours

Factory colours

  • NATO Green (IRR)
  • Deep Bronze Green

Codes on hover. Hex values are representative approximations of period paint unless a source states a measured value.

AI rendering impression

An AI rendering impression starts from the registry's own 3D model of this vehicle, which an image model then paints into a scene. It is an artist's impression of the type, made to give a feel for the vehicle in its element — not a photograph, and not a record of any particular vehicle.

Proportions, fittings, markings, colours and the setting can all drift from the original in the process. For the vehicle's actual details, rely on the registry's 3D renders, the specification and the cited sources on this page.

Sources

  1. 1The Vehicle Protection Kit (VPK) Land Rover in Northern Ireland ↗EMLRA · accessed 2026-09-17SOURCE
  2. 2Land Rover ½ ton Lightweight ↗Wikipedia · accessed 2026-09-17SOURCE
  3. 3https://emlra.org/articles/vehicles/the-vehicle-protection-kit-vpk-land-rover-in-northern-irelandhttps://emlra.org/articles/vehicles/the-vehicle-protection-kit-vpk-land-rover-in-northern-ireland ↗REFERENCE

Registry record updated 2026-09-17T21:31:25.761Z · status: researched